Haberle Model S 225 (manual)

Haberle Model S 225 (manual)
Item# S225
$3,925.00
Voltage:  Speed Selection: 

Product Description

The Haberle Model S225 uses a HSS Saw Blade (9") 225mm x 2.0mm x 32mm. This is an excellent saw for job sites and maintenance departments. This machine is best suited to cut small tubes and profiles of steel, stainless steel and nonferrous metals.

Safety Sawblade Guard Swing guided double guard made of cast aluminum, covers the sawblade totally in rest position. Moving the saw head, the guard opens in the cutting area only, for best operator's safety. Quick release lift-up system to change the sawblade.

Drive Gears Precision worm & wheel drive: Hardened and ground worm shaft. Strong main spindle runs in oil, free of maintenance. Special bronze wheel for long life. Available with standard or reduced speeds.

Vise Systems Machine comes standard with single mechanical vise. Strong buttress 27 x 4 mm (1.2"). Optional: double-grip vise with replaceable jaw plates, allows burr free straight cuts and profiled jaws for special applications. Maximum clamping range with jaw plates in place: 80 x 60 mm (3.1 x 2.4").

Cutting Range mm (Inches) with sawblade 225 mm sawblade flange 70 mm

Round Tube
70(2.7") 90
65(2.5") 45
55(2.2") 30 acute

Square Tube
60x60(2.5") 90
60x60(2.5") 45
50x50(2") 30 acute

Bar Stock
40(1.75") mild steel and nonferrous metals only

Machine Table, Pivot Bearing Mitering table allows acute mitering to the left within 60. Engraved 1 graduation, with quick stop bolt at 45, strong clamp bolt M12 (1/2"). In any position, the work-piece is supported on both sides close to the sawblade. Large double yoke pivot system with 100 mm (3.9") bearing length and cast iron base care for high stability.

Innovative Sawblade Lubrication Patented mechanical low-consumption lubrication system, specially designed to use the machine on sites and installation, cares for permanent oil supply to the sawblade without any air or electric power. A brush besides the sawblade applies pure cutting oil out of an oil cell. When starting to work, this cell has to be filled up with oil out of the 500 ccm tank by the hand operated oil pump placed on the tank. The oil cell and the capillary hose to the tank care for permanent oil lubrication for hours. Only very little oil is used up, the tank volume will last for more than 100 hours of operation. Machine, chips, material and workbench remain dry and clean. English instruction label on the tank.

Dimensions & Weights Table machine with handle: 650 x 300 x 720 mm, 48 kg (1101b.) Table machine, packed: 680 x 340 x 770 mm, 58 kg (130 lb.) Fabricated steel stand: 600 x 400 x 800 mm, 20 kg ( 45 lb.)

Standard Equipment Instruction manual in English with parts list, operating wrenches, single vise, mechanical oil lubrication system, 1 bottle with 1000 ccm cutting oil HABERLE S 2000.

Accessories